Setting the space between fence posts • Set the end or corner posts first.. Depending on the manufacturers, fences are ready-made and can be installed. Once you have your fencing materials, you will also need the following equipment: • Gate • Shovel or post hole digger • String • Level • Concrete • Concrete mixer • Any hardware needed for the gate if it is not included, like hinges and a latch. Installing panel. To attach the stringers you should cut them to fit between the posts and nail them to the posts. Fence Building The gravel will allow water tat collects at the bottom of the hole to drain away. Or you can place two to three shovels of gravel at the bottom of each hole to prevent rot and decay. Likewise, all of these materials are made to mark territories and provide homeowners with privacy. It is a simple procedure to get this right. Once your post holes are dug, you can start assembling your fence. Double check each post making sure it’s plumb. Fence Building . Vinyl fencing is nice because you don’t have to worry about replacing rotten boards and they hold up better to wind. Use a spacer to get a consistent distance between them and shovel dirt around them when you have the posts in position.
Thee string should be at the outside of this post, so you have to measure in from the string for center of the posts. If you do it by hand, be sure it is mixed well. Follow the directions on the bag of concrete to get it to the proper consistency. Fence Building This type of fencing does not need a lot of support from a fence post, it is not meant to be leant on. What design of the panel you like to have is up to you but it looks best if you keep the entire panel consistent and symmetrical. Next you need to treat your posts by following the manufacturers recommendations. You may choose to use a concrete mixer from the local tool rental agency, or you can mix it in a bucket by hand. 3. Mark a point on your house one-meter from the stake. Fence Building • Dig the holes to the appropriate deepness. If you don’t like uniformity, plant two, or even three, in front of one or two of the posts. It is hiding the fence that is your main expense. read on. While shrubs offer a boundary line, they can still be ‘crossed’ by dogs and children alike. It’s now time to prepare your concrete for setting the posts.
Fence Building it will look out of proportion. Do the same with posts that will manage big burdens. Finish filling each hole to about 2 inches below ground level. Finally attach the middle rail central between the bottom and top rails. Mark this with a stake so you can see them. Another reason for this is that while many people do not actually want a fence, sometimes, one becomes necessary. Fence Building Fasten a string to the stake and stretch it out roughly perpendicular to your house. Normally it’s enough to set them with dirt. If you’re in disagreement you can look for the property survey markers or if all else fails have your property surveyed. When you have all posts set hard, trim of the tops to get proper height. Sounds mysterious? Not really. Use a level to make sure the boards are vertically plumb. Fence Building Brace the post in place while the concrete cures. Add water and mix to a thick consistency but at the same time wet enough to pour all the way around the posts. To prevent water from running down between the post and the concrete you should fill the hole little bit higher than the ground and slope the top of the concrete away from the pole a little.